So the big day has arrived and you are ready to install on your new kitchen.
After speaking with many past clients we can offer the following advice.
- Firstly if you have the space ,assemble the new kitchen BEFORE you rip out the old
- It usually takes three the time to more put together the first module than the last.
- Remember they are just a series of boxes and once you have done one they are all basically the same.
- FINALLY- WHEN ALL ELSE FAILS – READ THE INSTRUCTIONS!!!
Assembly Instructions for:
Base Unit
![]() | 1. Each unit is wrapped individually. |
![]() | 2. Each piece is labelled for easy identification. |
![]() | 3. Screw base to back tightening with battery drill. |
4. Screw side on checking label for left or right. | |
![]() | 5. Make sure edges are flush as you go. |
![]() | 6. Turn over and repeat to other side. |
![]() | 7. Stand unit up and screw front rail. |
![]() | 8. Remember keep edges flush. |
![]() | 9. Lay down ready for adjustable legs. |
![]() | 10. Knock legs on gently with a hammer. |
Drawer
![]() | Box with drawer components. |
![]() | 1. Take a drawer bottom and metal sides. |
![]() | 2. Align side lugs with holes on bottom and push on. |
![]() | 3. Screw sides in place. |
![]() | 4. Turn over and slide back in place. |
![]() | 5. Screw back in place. |
![]() | 6. Screw bottom in place. |
![]() | 7. Attach bracket for side rail. |
![]() | 8. Clip rail to bracket. |
Drawer Unit
![]() | 1. Each drawer unit is wrapped individually. |
![]() | 2. Take sides and align runners with pilot holes. |
![]() | 3. Screw runners to sides with rollers to the front. |
![]() | 4. Knock in cabinet top connectors. |
![]() | 5. Screw base and back together. |
![]() | 6. Fit side with screws and tighten keeping flush. |
![]() | 7. Turn over and repeat to other side. |
![]() | 8. Stand unit up and screw front rail. |
![]() | 9. Knock on legs gently with hammer. |
Overhead
![]() | 1. Each overhead is wrapped individually. |
![]() | 2. Fit bottom to back with screws and tighten. |
![]() | 3. Fit side with screws and tighten. |
![]() | 4. Turn over and repeat to other side. |
![]() | 5. Finish by fitting top. |
![]() | 6. Tighten screws keeping edges flush. |
Soft Close Drawers
![]() | 1. Components for soft close drawers. |
![]() | 2. Align runners with front edge. |
![]() | 3. Tighten screws in place. |
![]() | 4. Sit bottom flat on bench. |
![]() | 5. Clip in back fixing brackets. Marked L & R. |
![]() | 6. Slide in back rail. |
![]() | 7. Screw back rail in place. |
![]() | 8. Select drawer front. |
9. Push in drawer front brackets. | |
![]() | 10. Lift with side movement to lock bracket in place. |